Mounting tom pads on the rack
1. Attach the tom pads (15) to the mounting rods (9) and tighten the wing nuts of the tom pads hand-tight.
2. Align the pads on the rack to meet your needs, then tighten the wing nuts of the brackets and the wing nuts of the tom
pads evenly.
Mounting cymbals on the rack
1. Unscrew the wing nuts from the cymbal holders (7) and take the felt washers o the holders.
2. Place the cymbals (13, 14) as shown in the gure on the holders. Be sure to attach the crash pad (12") to the left holder and
the ride pad (14") to the right cymbal holder.
3. Place the felt washers on the cymbals (13, 14) and x the cymbals with the associated wing nuts on the holders.
Assembly
e-drum set
14
To Next Page
Loading...
