Thomson Power Systems TS 970 User Manual

TS 970 Transfer Switch
PM163 REV 0 20/02/05 3 Thomson Power Systems
1. PRODUCT REVISION HISTORY
The following information provides a historical summary of changes made to this product since the
original release.
Operating & Service Manual Version
Rev 0 19/05/15
Original release.
Contact Thomson Power Systems, to obtain applicable instruction manuals or if in doubt about
any matter relating to installation, operation or maintenance. Soft copy of the most current
version is available at www.thomsonps.com.
NOTE: All information contained in this manual is for reference only and is subject to change
without notice.
Related Product Instruction Manuals
• TS 970 Quick Start Instruction Manual (100A - 400A), PM161
• TS 970 Quick Start Instruction Manual (600A - 1200A), PM168
• TS 970 Specific Breaker Information for Withstand Current Ratings, PM167
• TSC 900 Transfer Switch Controller, PM151
• TSC 900 Modbus
TM
Communication, PM152
Contact Thomson Power Systems, to obtain these instruction manuals. Soft copy of the most
current versions of these manuals are available at www.thomsonps.com.
2. EQUIPMENT STORAGE
The following procedures are required for correct storage of the transfer switch prior to installation.
2.1. ENVIRONMENTAL CONDITIONS
CAUTION
Failure to store and operate equipment under the specified environmental conditions
may cause equipment damage and void warranty.
2.1.1. EQUIPMENT STORAGE
The transfer switch shall be stored in an environment with a temperature range not
exceeding -4° to +158° Fahrenheit (-20° to +70° Celsius) and a humidity range not
exceeding 5%-95% non-condensing. Before storing, unpack sufficiently to check for
concealed damage. If concealed damage is found, notify the ATS supplier and the

Thomson Power Systems TS 970 Specifications

General

Brand	Thomson Power Systems
Model	TS 970
Category	Switch
Language	English