THOMSON 1450 - Tape Player Operations; Tape Playback and Recording; Auxiliary Input Usage

8
Tape player
Playing a tape
1. Press TAPE
2. Press PUSH/OPEN to open the tape deck door
3. Insert a tape into the door and push the door closed
4. Press (TRACK REV) or (TRACK FWD) to position the tape to the desired
starting position
5. Press PLAY
6. Press REV. MODE to select continuous play with auto reverse or one-time auto reverse play
Recording to tape
From tuner
1. Insert a tape into the deck
2. Press TUNER to access the desired radio band
3. Tune to the station to be recorded
4. Press RECORD to begin recording
5. Press STOP to end recording
From CD (Synchronous Recording)
Synchronous recording will start and end as CD play (normal or programmed) starts and ends.
1. Insert a tape into the deck
2. Press CD
3. Insert the disc to be recorded
4. Select the track or program to be recorded
5. Press RECORD to begin synchronous recording
6. To end CD play and recording earlier, press STOP
From an auxiliary input
1. Insert a tape into the deck
2. Check that the auxiliary device has been connected correctly to the AUX connectors on the back of
the audio system
3. Start playback on the auxiliary device
4. Press RECORD to begin recording
5. Press STOP to end recording
Auxiliary input
This audio system can receive audio signals from other devices, such as a television, VCR, tuner,
satellite, or DVD player and output them through the connected speakers. To listen to such output,
1. Insert one end of an audio cable (not supplied) into the AUX IN jacks on the back panel
2. Connect the other end of the audio cable to another equipment and play the device
3. Press AUX on the front or remote
4. Adjust to your desired volume level and sound effects
EN
AM1450 Eng Version 3/27/00, 4:34 PM8