Getting Started
EN
9
Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator for
balancing the channels. As the signal "travels" from chan-
nel to channel, adjust the level controls until each channel
plays at the same loudness level.
Please refer to “Fine setting your speaker” section for more
details.
Level adjustment & surround channel level
expectation
Even though you adjust the surround channel to be as loud
as the others on the test signal, you'll find that on actual
program material the surround channel is usually much
lower than the front. Don't be tempted to re-adjust the
surround level; program producers use surround mostly for
subtle atmosphereics and ambience, and only rarely for
special effects. A good surround mix doesn't call attention
to itself; if it did, it would soon become distracting.
Factory Setting
The unit is preset to the following setting when you first
turn on the power.
Function = DVD/CD
Volume setting = 16
Bass & Treble = 0 dB
Channel level = 0 dB
Subwoofer = STRONG
Restore to default settings
When the receiver is on and the disc tray is opened, press
SUBWOOFER for 5 seconds until the screen goes black,
then the initial language selection menu will appear.
All system settings will be restored to default, the parental
password will also be reset.
Dolby Digital
Manufactured under license
from Dolby Laboratories.
“Dolby”, “Pro Logic” and
the double-D symbol are
trademarks of Dolby
Laboratories. Copyright
1992-1997 Dolby
Laboratories, Inc. All Rights
Reserved.
Courtesy Dolby Laboratories
Manufactured under license from
Digital Theater Systems, Inc. U.S. Pat.
No. 5,451,942; 5,956,674; 5,974,380;
5,978,762; 6,226,616; 6,487,535 and
other U.S. and world-wide patents issued and pending.
"DTS" and "DTS Digital Surround" are registered
trademarks of Digital Theater Systems, Inc. Copyright
1996, 2003 Digital Theater Systems, Inc. All Rights
Reserved.
4
5
6
Note:
All preset radio stations and surround
sound setting will be lost after the facto-
ry setting is restored.
To Next Page
Loading...
