THOMSON ROCZ107 - Special Functions; Punch Through Channel; Punch Through Volume; Macro Power

6. Special Functions
6.1 Punch Through Channel
The Punch Through Channel allows the CH+ or
CH- commands to bypass the currently controlled
device and switch the channels on asecond device.
All other commands remain uninuenced.
To activate the punch through channel setting:
•Press desired device mode key (e.g. TV).
•Press and hold “CH+” key.
•Press desired device mode key (e.g. SAT).
•Release “CH+” (the indicator ashes once if the
setting is activated).
To deactivate the punch through channel setting:
•Press desired device mode key (e.g. TV).
•Press and hold “CH-” key.
•Press desired device mode key (e.g. SAT).
•Release “CH-” (the indicator is ashing twice if
the setting is deactivated).
6.2 Punch Through Volume
The Punch Through Volume allows the VOL+ or
VOL-commands to bypass the currently controlled
device and adjust the volume on asecond device.
All other commands remain uninuenced.
To activate the punch through volume setting:
•Press desired device mode key (e.g. TV).
•Press and hold “VOL+” key.
•Press desired device mode key (e.g. SAT).
•Release “VOL+” (the indicator ashes once if
the setting is activated).
To deactivate the punch through volume setting:
•Press desired device mode key (e.g. TV).
•Press and hold “VOL-” key.
•Press desired device mode key (e.g. SAT).
•Release “VOL-” (the indicator is ashing twice if
the setting is deactivated).
6.3 Macro Power
MacroPower enables you to turn two TV/STB
devices on/off simultaneously.
To activate the macropower setting:
•Press desired device mode key (e.g. TV).
•Press and hold “POWER” key.
•Press desired device mode key (e.g. SAT).
•Release “POWER” (the indicator ashes once if
the setting is activated).
To deactivate the macropower setting:
•Press desired device mode key (e.g. TV).
•Press and hold “POWER” key.
•Press desired device mode key (e.g. SAT).
•Release “POWER” (the indicator is ashing
twice if the setting is deactivated).
7. LEARN MODE
This remote control is equipped with alearning
function. Thus, you could learn functions of your
original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
•The batteries in the two remote controls have to
be in good condition. Replace them if necessary.
•Place the remote controls with the infrared
diodes so that they point towards each other.
•Wherenecessary adjust the height of both
remotes so that infrared diodes areproperly
aligned.
•The distance between the remote controls should
be about 3cm.
ca. 3cm
ROC1117GRU
ORIGINAL
TV
STB
Prog
Vol
Prog
Vol
AV
ZAPPER
4