THOMSON RR300 - Wake to Tone; Wake to Radio; Cancel Wake Settings

EN
EN
9
Operating the Clock
Turning off Alarm
Silence the alarm momentarily
Press SNOOZE to turn the alarm off
temporarily. The alarm will sound again
when the snooze period is over.
Stop the alarm
Press . Then, the alarm will be on the
following day at the same time.
Note:Note:
Note:Note:
Note:
When AC power is interrupted
and the unit is operating
through the DC backup
batteries, all wake mode will
work with buzzer instead.
Tip:Tip:
Tip:Tip:
Tip:
You can activate the previously
set alarm time by pressing the
WAKE 1 WAKE 1
WAKE 1 WAKE 1
WAKE 1 or
WAKE 2 WAKE 2
WAKE 2 WAKE 2
WAKE 2 button.
Sleep Mode
In sleep mode, the unit will turn off
automatically after a specified time.
Setting Sleep Time
1. Press SLEEP then the time display will
exhibit 0:59 and the radio will turn
on.
2. While holding SLEEP, press REV or
FWD to set the sleep time.
3. Release SLEEP and the display reverts
to current time.
Note:Note:
Note:Note:
Note:
The sleep time range is from 1
minute to 2 hours.
8
Operating the Clock
Note:Note:
Note:Note:
Note:
The unit equips with
GRAD-U-GRAD-U-
GRAD-U-GRAD-U-
GRAD-U-
WAKEWAKE
WAKEWAKE
WAKE feature, the alarm tone
volume will increase gradually to its
maximum in about 30 to 45 seconds.
Tip:Tip:
Tip:Tip:
Tip:
If you set SLEEP function with
low volume level before going to
bed, we advise using Wake to
Tone mode to wake you up since
its volume will automatically
increase.
Wake to Tone
When wake to tone is selected, the red
indicator lights beside the icon.
Wake to Radio
When wake to radio is selected, the red
indicator lights beside the icon.
Setting Wake Station
1. Select radio band.
2. Select desired station.
3. Adjust the volume by turning
VOLUME.
Cancel Wake Settings
To cancel the wake function
permanently, press WAKE 1 or WAKE 2
repeatedly until the red indicator beside
the corresponding wake icon turns off.