THOMSON RR300 - Nap Mode

EN
EN
Operating the Clock
Note:Note:
Note:Note:
Note:
Nap will not be activated again
the following day at the same
time.
Nap alarm is equipped with
GRAD-U-WAKEGRAD-U-WAKE
GRAD-U-WAKEGRAD-U-WAKE
GRAD-U-WAKE feature.
11
View NAP time
Press NAP once to show time left.
Cancel NAP
Press and hold NAP until the NAP
indicator turns off and the current time
shows on the display.
Stop the Nap alarm
Press NAP or follow “Turning off Alarm”.
Snooze Operation
This operation allows extra sleep time
after the alarm is on.
The alarm can be turned off
temporarily until the snooze period is
over by pressing SNOOZE .
Snooze function can be used
repeatedly up to 2 hours. After this,
the alarm will turn off until the next
alarm conditions are met.
Set the “quiet” period as follow:
1. Press and hold SNOOZE.
2. Press REV or FWD to adjust
snooze time. Release button, then,
the “quiet” period is set.
Note:Note:
Note:Note:
Note:
The “quiet” period is from 1
minute to 30 minutes. (the
default time is 9 minutes)
Nap Mode
This function wakes you up after a short
period of time. Only alarm sound can be
selected for NAP.
1. Press and release the NAP buatton.
The NAP indicator flashes.
2. During this period, adjust nap time by
pressing REV or FWD.
3. Press NAP to confirm nap time or if
no button is pressed after 5 seconds,
the clock will be shown. The NAP
indicator lights.
Note:Note:
Note:Note:
Note:
The nap range is from 10 minutes
to 2 hours.
Tip:Tip:
Tip:Tip:
Tip:
Nap time increases and
decreases at an interval of 10
minutes.
10
Operating the Clock
Note:Note:
Note:Note:
Note:
When
SLEEP SLEEP
SLEEP SLEEP
SLEEP is activated agaain,
the sleep time will be the same
as the one you have set before.
Sleep to Radio
The radio is turned on after step 1 in
Setting Sleep Time and you may
select the station as usual. The radio
will turn off when the preset time
elapses.
If you decide to turn off the radio sooner,
press SNOOZE or .
View Remaining Sleep Time
Press SLEEP to read the remaining
sleep time.