10
WASHING
Before the First Wash Cycle
To remove any residual water left during testing by the manufacturer, it is recommended that you carry
out a short wash cycle without laundry.
1. Turn on the tap.
2. Close the door.
3. Pour a little detergent (about 30 ml) into the main wash compartment of the detergent dispenser.
4. Select and start a short programme.
Washing Your Laundry
1. Open the door to load the articles into the drum.
DO NOT OVERLOAD the appliance.
Observe the load sizes given in the programme chart.
Overloading the appliance will result in washing results.
2. Close the door.
Make sure that no laundry gets stuck between door and door seal.
3. Add detergent and softener.
Pull out the drawer.
Add detergent and softener into the corresponding compartments.
Do not overfilling.
4. Turn the water supply on.
5. Select the desired programme.
Turn the programme dial to
select the required programme.
The display will show the washing time.
The programme selector is also used for
switching the machine on or off.
For detailed overview of programmes,
see Programme Chart.
To Next Page
Loading...
