18
1. Close water tap and unscrew the inlet hose. 2. Clean the mesh filter at the hose end
carefully with a fine brush.
3. Unscrew the inlet hose on the back of the appliance by
hand. Pull out the mesh filter from the valve on the back of
the appliance with pliers and carefully clean it under
running water.
4. Insert the mesh filter back in the
appliance. Connect the inlet hose to
the water tap and appliance. Open the
water tap and check that all
connections are tight.
Cleaning the Detergent Drawer
1. Remove the drawer by pressing on the release button and at the same time pulling the drawer out
of the appliance.
2. Clean all parts under running water using a soft brush, removing all detergent or softener residues.
3. Clean the drawer recess in the appliance using a soft brush.
4. Reinstall the drawer and push it back into position.
NOTE :
It is recommended to clean the detergent drawer from time to time.
Never use chemical or abrasive cleaning agents.
Release
button
To Next Page
Loading...
