INTERIOR
THOR MOTOR COACH | MADE TO FIT
63
9
CONVERTING THE L-SHAPE SOFA TO A BED:
e sofa can be converted to a bed with the L-Shape seat
expanded or contracted.
1. Remove the back two cushions and place them to the
side (Figure 7).
2. Grasp the bottom of the seat cushion, li up AND pull
towards you. With this motion, the back panel should
begin to rotate and move in a downward motion
(Figure 8).
3. Move your hands to the top of the cushion and con-
tinue to push it downward until it is in a horizontal
position (Figures 9 and 10).
4. Place the two back cushions on the horizontal back
panel. is completes the bed conversion (Figures 11
and 12).
Figure 7 Figure 8
Figure 10 Figure 11
Figure 12
Figure 9
NOTE: Sofas are usually fitted with safety belts, which may fall into the sofa base during bed conversion. When
converting the bed back to a sofa, be sure to feed the safety belts through the space between the bottom cushion
and back panel so that the safety belts are available for passenger use.
TO RETURN THE BED TO A SOFA:
1. Li the leading edge of the bottom cushion to approx-
imately 45 degrees.
2. Push the leading edge of the bottom cushion in a
downward and forward direction. is will also li
the back panel. Grasp the top of the back panel and
pull towards you while continuing to push the bottom
cushion downward and into the sofa base.
3. When the back panel is in its vertical position, lower
the bottom cushion to its horizontal seating position.
4. Place the two back cushions along the back panel, in
their up-right seating position.
To Next Page
Loading...
