THORENS TD125 - AC Mains Power; Speed Selector

6.2. AC Mains power
supply switch
The slide bar © on the control panel has two positions:
Left position: OFF
Right position: ON
The synchronous motor is controlled by the solid state
control system. There is a built in automatic overload
protective
circuit.
Therefore
no
damage
will
occur
if
the
turntable
platter
is
stopped
by
hand
when
the
power
is on,
16
6.3. Speed selector
The slide bar on the left hand side of the contro!
panel @ is the speed selector for the three speeds
16 #/s, 33 '/s and 45 RPM.
It-can be operated at any time whether power is on or
off. The fine speed adjustment is made by the red
knurled whee! @ in front of the illuminated stroboscope
window @, The turntable speed is increased when the
knurled wheel is moved to the left and decres
moved to the right
When the appropriate stroboscope pattern
the following record speeds will be obt
following mains frequen!
At 50 Hz 45.11 RPM and 33.33 RPM
‘At 60 Hz 45.00 RPM and 33.33 RPM
When using the 162/ RPM speed, correct speed will
be indicated by the 33 '/s stroboscope pattern.