THORENS TD125 - Page 9

4.4.
Assembling
of
longer
length
tone
arms
The TD 125 is supplied
ting board to accommodate 9° (Brit
(American Standard) tone arms.
The turntable TD 125 may be equipped with a longer
tone arm. For the purpose a conversion kit JP 512 Is
ailable. It consists of @ larger tone arm mounting
board and a longer control panel. For this conversion,
follows: — after unscrewing the 3 sock
1d screws remove the standard tone arm mour
ting board. — Remove outer and inner turntable plat-
ters. — Loosen earth connection (cable) between upper
id lower chi Unscrew the 3 knurled nuts @
and remove the washers below. — Remove the upper
die cast chassis, taking care not to lose any part of
the spring suspension of this chassis. — Unscrew the
fastening screws of the slide buttons ® and remove
the buttons. — Unscrew the 3 screws maintaining the
control panel which become accessible after removal
of the die cast chassis. — Remove the standard control
panel.
For assembling the longer control panel and the larger
tonearm mounting board, proceed accordingly in re
erse sequence.
The conversion enlarges the turntable by 75 mm (2.957),
This also requires the longer base No ST 512.
ish Standard) 12