Optical Chopper System
18488-D02 Rev G, September 24, 2012 Page 18 www.thorlabs.com
6.4. Blade Indexes
Blade type can be gotten or set through the command line interface using the commands “blade?” and
“blade=
n”, respectively. These commands do not denote blade type using product names. Rather, they
index blade type using the numbers from 0 to 7. The following table provides the mapping:
Blade Index
MC1F2 0
MC1F6 1
MC1F10 2
MC1F15 3
MC1F30 4
MC1F60 5
MC1F100 6
MC1F57 7
To Next Page
Loading...