The brake pedal’s resistance can be adjusted by replacing or mixing the main F springs:
- Reposition the different elements and the main springs (F10, F15, F20 or F30) of your choice
(along with the appropriate spacers) on the holding rod.
1 white F10 spring
+ 1 grey F15 spring
Weak resistance
+ 1 black F20 spring
Medium resistance
Don’t hesitate to mix and test out the different springs (a variety of different combinations
are possible) in order to find the level of resistance that suits you best.
Once you have modified the resistance, connect the pedal set to a PC via the removable USB
cable (1), then carry out a new calibration of the brake pedal via the calibration software.
This
new calibration (corresponding to the new brake pedal resistance) will automatically be saved in the
pedal set’s internal memory, and will be effective in all of your games on PC and game consoles.
VERY IMPORTANT
The pedal set’s default calibration at the factory is carried out with one grey
F15 spring and one black F20 spring (medium resistance). In the event that
you change the springs (and therefore the brake pedal’s resistance), you
must recalibrate the brake pedal using the calibration software on PC: should
you fail to do so, the brake pedal will not function properly on PC or game
consoles.
To Next Page
Loading...
Need help?
General
