Thule Cadence - Installing the Safety Flag; Installing ezHitch with Quick-Release

51100986 - A
11
3
2
4
4.7.1 InstallIng the safety flag
A. Inserttheagpoleintothemetalorplasticcollaronthe
safetyag.
B. Inserttheagpolethroughthesleeveonthelefthand
sideofthebody.(seeimage1)
4.7 cyclInG
1
4.7.2 InstallIng the ezhItch
tM
wIth a
QuIck-Release
A. Verifythatthequickreleaseskeweriscompatiblewith
yourbicycle.
B. Completelyunscrewandremovethequick-release
knobfromthequickreleaseskewer.
C. Removeoneofthespringsfromthequick-releaseskewer.
D. Insertthequick-releaseskewerthroughtheezHitch™.
(Seeimage2)
E. Insertthequick-releaseskewerintothebicycleaxle
fromtheleftsidepointingright.
F. Replacethespringbackontothequick-releaseskewer,
narrowendpointinginwards,towardsthebicycle.
G. Closethequick-releaselever.
H. Replaceandtightenthequickreleaseknobuntil
thumbtight.
I. Openthequick-releaselever.(Seeimage3)
J. Tightenthequick-releaseknobanotherfullturn.
K. Closethequick-releaselever.(Seeimage4)
L. Verifythatthebicyclewheelissecurelyattachedto
thebicyclebygivingitasharppull.
WARNING
The quick-release knob must be tightened on
the quick-release skewer completely with at
least two screw threads showing past the end
of the quick-release knob to ensure the rear
wheel of the bicycle does not loosen off.
Always make sure that the quick-release is
correctly attached. An incorrectly tensioned
quick-release may lead to accidental loosening
of the rear wheel.