Thumpstar KXD - Shifting Gears

8
Shifting Gears
umpstar recommended engines
from 50cc to 180cc use this gear pattern
Some umpstars bike, ATV models and
Zongshen 190cc is using a dierent gear pattern
including an extra 5th gear.
Your motorcycle has four forward gears.
To start riding, aer engine has been warmed up and the
side stand raised:
1. Close the throttle and pull the clutch lever in.
2. Raise the shi lever from neutral up to rst gear.
3. Release the clutch lever. Gradually open the throttle.
4. When you attain a moderate speed, close the throttle, pull the clutch
lever in and raise the shi lever. Aer shiing, realese clutch and
apply the throttle.
5. To continue shiing up to each higher gear, repeat step 4.
6. To shi down to a lower gear, close the throttle, pull the clutch lever
in and depress the shi lever. Aer shiing, apply the throttle
Remember to close the throttle before shiing.
NOTICE:
Improper shiing may damage the engine, transmission, and drive train.
0
4
1
2
3