5
a. Install the antenna into transmitter.
b. Check the frequency printed on the transmitter crystal.
c. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter
crystal. Make sure no one will operate on the same frequency when you are. When there is a radio
glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the
same frequency.
PREPARING THE RADIO
6
a. Install 8 AA-size alkaline batteries into transmitter.
b. Undo the large zip-tie, and install 4AA alkaline batteries into receiver battery box.
c. Secure the receiver with batteries back onto the radio plate with the large zip-tie.
RADIO BATTERY INSTALLATION
a b c
4
a.
When turning radio on, first turn on the transmitter.
b. Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off.
c. To reverse the functions of servos, use the small, white servo reverse switches located on side of the
pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter).
To trim the servos on pistol transmitter, use the trim switches on side of the steering wheel (the ST.
trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim levers are located
accordingly around the sticks.
d. For more details, please check the transmitter instruction manual.
RADIO OPERATION
a
b
c
a c
7
b
a
c
To Next Page
Loading...
Need help?
General
