EasyManuals Logo

Thytronic NA10 User Manual

Thytronic NA10
177 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
FUNCTION CHARACTERISTICS
57
NA10 - Manual - 04 - 2022
If the IE>BLK2IN, IE>>BLK2IN and/or IE>>>BLK2IN parameters are set to ON and a
binary input is designed for selective block (Block2), the protection is blocked off by phase ele-
ments (Block2 Iph) or by any protection element (Block2 Iph/IE) according the selectivity block
criteria.
[1]
The enable IE>BLK2IN, IE>>BLK2IN and/or IE>>>BLK2IN parameters are avail-
able inside the Set \ Profile A(or B) \ Residual overcurrent-50N/51N \ IE> Element (IE>> Element,
IE>>> Element) \ Setpoints menus, while the Block2 Iph and Block2 Iph/IE functions must be
assigned to the selected binary inputs inside the Set \ Inputs \ Binary input IN1(2) menus (IN1 or
IN2 matching).
Use of committed pilot wire output BLOUT1:
The information about phase or phase+earth block may be select programming the ModeBLOUT1
parameter (OFF - ON IPh - ON IPh/IE - ON IE) inside Set \ Profile A(or B) \ Selective block-
BLOCK2 \ Selective block OUT menus.
Use of output relay (K1...K6):
If the IE>BLK2OUT, IE>>BLK2OUT and/or IE>>>BLK2OUT enable parameters are set to
ON and a output relay is designed for selective block (Block2), the protection issues a block output
by phase elements (BLK2OUT-Iph) or by any protection element (BLK2OUT-Iph/IE), whenever the
given element (Start IED>, Start IED>>, Start IED>>> and/or Start IED>>>>) becomes active. The
enable IED>BLK2OUT, IED>>BLK2OUT, IED>>>BLK2OUT and/or IED>>>>BLK2OUT
parameters (ON or OFF) are available inside the Set \ Profile A(or B)\ Residual overcurrent-50N/51N
\ IE> Element (IE>> Element, IE>>> Element) \Setpoints menus, while the BLK2OUT-Iph-K, BLK-
2OUT-Iph/IE-K and/or BLK2OUT-IE-K output relays and LEDs (BLK2OUT-Iph-L, BLK-
2OUT-Iph/IE-L e/o BLK2OUT-IE-L) must be select inside the Set \ Profile A(or B) \ Selective
block-BLOCK2 \ Selective block OUT menu.
Note 1 The exhaustive treatment of the selective block (Block 2) function may be found in the “Selective Block” paragraph inside CONTROL AND
MONITORING section

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thytronic NA10 and is the answer not in the manual?

Thytronic NA10 Specifications

General IconGeneral
BrandThytronic
ModelNA10
CategoryRelays
LanguageEnglish

Related product manuals