TIC B Series

B-series Instruction Manual
Installation/Maintenance Note
• The B series speaker can be installed in-ground or surface-mounted. In-ground installation is generally optimal since burying speaker in-ground will
enhance its resonance, providing a fuller audio experience. When mounted on a surface, please ensure the wiring is safely secured and does not
become a tripping hazard. When burying the speaker in-ground please make sure to keep the open part of the speaker free from soil, and in addition
a small part of the bottom section as well (see below picture).
• For in-ground installation, only burial-grade insulated speaker wires should be used. Conduit can be used alternatively in conjunction with standard
speaker wires. Wire/conduit should be buried 10 - 15 cm underground.
• For connecting/extending speaker wires, we highly recommend using waterproof wire connector (ie. SPC-CN1).
• Alternately, silicon can be applied to the opening of standard wire nut to provide water protection.
• The B series is designed to be water-resistant, but not to be fully waterproof. It is not designed to be protected against total water submersion, such
as heavy flooding. With the raised, downward facing profile, it’s unlikely for the speaker to be submerged in water under normal rain and snow
condition. Please use caution and consider relocating the speaker when there is chance for heavy flood or snowfall.
• System should be fully tested above surface before speakers and wires are buried.
• If sound is muddled or multiple speakers are not in sync, please check to ensure wire polarity is correct.
• To clean speaker, you can rinse with fresh water from directly above the speaker and wipe with a cloth. If needed, use mild detergent to remove dirt.