APPROACH THE ROUTER
Download the complete Imola/Lipari User Guide at www.tiesse.com
USERNAME AND PASSWORD
In order to access router, login and password need to be specified.
Factory configuration is:
login: root
password: tiesseadm
It is possible to change the root user password thanks to the CLI command:
change_password root
which in interaction modality asks to introduce the new password.
PASSWORD RECOVERY PROCEDURE
On certain models of router, if you use a serial connection, you can apply as follow:
At the router prompt, press simultaneously the key “Shift” (uppercase button) and the key “z”
When the prompt is up, type the commands:
setenv config factory
saveenv
boot
With those commands the router reset itself to the factory configuration and the previous settings are lost.
REBOOT OF THE ROUTER
The router can be rebooted using the command:
reboot
After the reboot, all the unsaved changes (through the command save), will be lost.
A time programmed reboot can be configured, specifying after how many seconds this must be done. The
command is:
schedule-reboot wait N
The command prompt is returned to the user, so that other commands can be executed or to end the
current session.
The programmed reboot can be disabled with the command:
no-schedule-reboot
To Next Page
Loading...
