Sent: 14-01-21 09:48:59
Received: 70-01-01 17:07:23
IMSI: 222016702779444
Length: 36
Text Message: Send confirmation sms just as you did
-------------------------
Press Enter to continue...
MOBILE SERVICE CONNECTION: THE HELLO COMMAND
Imola can send a message which contains some useful information about the mobile session to a remote
server, so that messages can be stored.
The command is:
hello <rem-host> <rem-port>
where:
<rem-host> is the remote server IP address.
<rem-port> is the IP port value on the remote host
The message sent will have following format:
00:0d:5a:07:01:13,222017392670415,355841030174450,6 CSQ (-101 dBm), HSDPA I TIM, IMOLA@217.1.1.1
The field separator is „,‟ (comma) and the fields are:
Router MAC Address
SIM Card IMSI installed on router
Mobile module IMEI
CSQ value (6) and dBm (-101) conversion
Connected network (HSDPA) and provider (TIM)
Router Hostname@ IP address
Using the following sequence of commands, the hello message can be regularly sent:
set timer-tick 600
set trigger timer-tick hello 85.34.166.18 22000
The message is sent as a UDP packet. If destination port specified is 514 (syslog service) and the syslog
server is enabled on the remote server, data will be directly collected from this syslog service.
SIM PIN UNLOCK
The activation of mobile session requires that the SIM is devoid of PIN code. When this code is set, it is
possible to deactivate it by using the command:
unlock-sim
This command checks the presence or lack of the PIN code. For example, if the PIN code is not present, the
result of the command is:
root@IMOLA> unlock-sim
AT+CPIN?
To Next Page
Loading...
