EasyManua.ls Logo

Tiesse Imola - Page 33

Tiesse Imola
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mobile interface
IMOLA/LIPARI QUICK START GUIDE
set sms helper-number +3933523054400,+3933523223223
Finally, to enable the messaging service with the newly introduced parameter, you should run the CLI
command:
set sms on
Once the service is properly set up and activated, messages can be sent by the router, using the command:
send-sms -d {NUMBER1[,NUMBER2[,NUMBER3[,...]]]} {TEXT_MESSAGE}
It is possible to send a text message to multiple phone numbers, as long as these are specified by
separating commas and no spaces between them. In addition, a telephone number must be strictly
specified with the prefix Country Code (with or without the + beginning). For example, to forward an SMS
to two telephone numbers of mobile network 335-23054400 and 335-23223223, the helper command to
enter is:
send-sms -d 3933523054400,3933523223223 TEXT_MESSAGE
To send messages at certain stages of operation of the router or sending SMS to lift the occurrence of
certain events (see sections concerning the programming of triggers related to various interfaces and / or
services of the router), you can launch by sending SMS commands, associating the same commands to the
most appropriate triggers in relation to the circumstances of execution.
Example :
The Mobile modem is active and you wish to receive informations via SMS in relation to the time when the
modem connects, or it goes in stand-by mode; you can use commands like:
set trigger gprs up send-sms -d +3933523054400 Mobile Interface just connected
set trigger gprs down send-sms -d +3933523054400 Mobile Interface in stand-by now
The messaging service offers an interface for reading SMS conventional messages, by which is meant the
whole of those messages not containing executable commands from the router. It is possible to read
received messages from the modem using the following commands:
to view unread SMS: show sms new
to view read SMS: show sms read
to view all SMS: show sms all
For example with
show sms all
all received messages are displayed and the output will be similar to:
-------------------------
From: 393495311921
From_SMSC: 393258819001
Sent: 14-01-21 09:48:59
Received: 70-01-01 17:07:23
IMSI: 222016702779444
Length: 57
Text Message: Service communication go to sector A asap
-------------------------
Press Enter to continue...
-------------------------
From: 393495310926
From_SMSC: 393358819001

Related product manuals