you configure the router so that, upon receipt of an SMS Tiesse CLI commands, it also provides the same
output of any response to the sender. As an example, suppose you have configured the SMS messaging
with password "TIESSE" and assume that you have configured the router with the sms reply. If you want to
receive from remote information relating to the status of the phone, simply send an SMS to the router CLI
command:
TIESSE show interface gprs status
After the router received the message and processed its content, it will send to a SMS to the sender like
this output:
root@LTE> show interface gprs status
Signal Power: CSQ = 13 => -87 dBm
Network: HSDPA/UMTS I TIM
HSDPA Category: 24 HSUPA Category: 6
Current Time: 59199 Temperature: 33
Bootup Time: 1 Mode: ONLINE
System mode: WCDMA PS state: Attached
WCDMA band: WCDMA 2100
WCDMA channel: 10638
GMM (PS) state:REGISTERED NORMAL SERVICE
MM (CS) state: IDLE NORMAL SERVICE
WCDMA L1 State:L1M_PCH_SLEEP LAC: EEB5 (61109)
RRC State: DISCONNECTED Cell ID: 0455346A (72692842)
RxM RSSI C0: -89 RxD RSSI C0: -106
RxM RSSI C1: -106 RxD RSSI C1: -106
Current Netwrk Technology: 0,HSDPA/HSUPA
Available Netwrk Technology: 1,UMTS,HSDPA/HSUPA
Supported Netwrk Technology: 2,GSM,GPRS,EDGE,UMTS,HSDPA/HSUPA,HSPA+,LTE
HSDPA/UMTS I TIM
GPRS subsystem is not active on this system.
set sms pin {PIN}
This command allows to send and/or receive SMS from the router even when the SIM card with a PIN code
is still on board. Thanks to this command, in fact, the messaging tool is able to enter the PIN each request
coming from the modem, the opening of each connection to it for the purpose of reading or sending
messages.
set sms helper-number {NUMBER1[,NUMBER2[,NUMBER3[,...]]]}
This command allows to forward every received message to the one or more telephone number specified
as argument.
In case of multiple telephone numbers, these must be separated by commas and without space between
them. In addition, a telephone number, must be strictly specified with the Country Code prefix (with or
without the + beginning). For example, to forward an SMS to two different telephone numbers like 335-
23054400 and 335-23223223, the helper command is:
set sms helper-number 3933523054400,3933523223223
or:
To Next Page
Loading...
