COMMAND-LINE INTERFACE (CLI) GUIDE
Tiesse CLI has an online help which helps the user in formulating all the available commands
in a way which is syntactically and semantically correct.
Pressing the <TAB> key twice or the “?” character, all the available commands will be displayed, followed by
a brief description.
Command-line completion or display of available alternatives is possible using the <TAB> key.
When the command is incomplete, a help function is automatically called: it provides all the necessary
information for a correct completion.
Tiesse spa - IMOLA Interworking Unit
No Radius configured. Using Local authentication
login: root
Password: *********
local: Authentication OK
Service Type is: Administrative-User
Idle timeout is set to 600 seconds
Connected Users:
ttyp0 recovery_user
root@Imola>
# download record show
add_user exit restore su
help traceroute
upload change_password
ping save version clear_counter
quit set who del_user
reboot shell
root@Imola>
Some of the available commands are displayed by pressing the <TAB> key twice or ? key
root@Imola> set ?
adsl Configure adsl
alias Configure secondary address
autocmd Configure Command executed automaticaly at boot time
backup Configure Backup procedure and criteria
banner Configure banner
bgp Configure BGP Protocol
ospf Configure OSP Protocol
rip Configure RIP Protocol
eth0 Configure eth0 parameter
vrrp Configure VRRP Protocol
gre Configure GRE tunneling
....
root@Imola>
Command-line completion and listing of parameters by pressing the <TAB> key.
root@Imola> set eth1 ?
To Next Page
Loading...
