set eth1 ipaddr Configure IP address
set eth1 broadcast Confgure Broadcast Address
set eth1 dhcp-client Enable DHCP Cleinte
set eth1 netmask Configure Netmask
set eth1 description Configure a description
set eth1 no-description
....
root@Imola>
Online help
The basic rules for the setup of an interface or a service include the configuration and activation of the
configured parameters.
The commands are divided in 3 groups:
configuration command set <options>
display command show <options>
management and administration commands.
It is very common to set the configuration command by Copy&Paste: you just have to copy the
configuration from a file on your computer and then paste it in the router‟s cli.
If the command lines are many, like more than 20, and the connection to the router is made by a serial
port o via a slow connection, it can happen that some of the pasted lines are not executed. To avoid this
problem, you can use the command set-config which puts the router in an “acquiring configuration”
state, so you can paste how many command line you need.
Here is the set-config screen:
root@IMOLA> set-config
Please Copy&Paste your configuration below and then
terminate with a single "." in a new line.
Your configuration will be imported and set as current.
To abort this session and let everything unchanged type "abort".
Put here your configuration:
To Next Page
Loading...
