set wifi wlanx encryp [open | wep | wpa-psk | wpa-eap]
Depending on the chosen encryption type, you can add other parameters. If the encryption is open, the
Wi-Fi network is "open", i.e. does not require authorization
set wifi wlanx encryp open
If the encryption is wep, the network is “closed”, it needs authorization with Pre-Shared-Key.
set wifi wlanX encryp wep [crypted-password | password] <STRING>
If the encryption is wpa-psk, the network is "closed" and requires authorization by the Pre-Shared-Key
set wifi wlanx encryp wpa-psk version [1|2|auto] [crypted-password | password] <STRING>
If the encryption is wpa-eap, the network is "closed": authentication, authorization and accounting are
given by the RADIUS Server
set wifi wlanx encryp wpa-eap <options>
Where <options> can be:
the address of the accounting server
set wifi wlanX encryp wpa
-eap
accthost
<ADDRESS>
the port of the accounting server (default 1813)
set wifi wlanX encryp wpa-eap acctport <NUMBER>
secret shared key with the accounting server
set wifi wlanX encryp wpa-eap acctsecret <STRING>
authentication server address (default 127.0.0.1)
set wifi wlanX encryp wpa
-eap
authhost
<ADDRESS>
authentication server port (default 1812)
set wifi wlanX encryp wpa-eap authport <NUMBER>
secret shared with the authentication server
set wifi wlanX encryp wpa-eap authsecret <STRING>
NAS identifier
set wifi wlanX encryp wpa-eap nas-identifier <STRING>
re-authentication interval (default 600 seconds)
set wifi wlanX encryp wpa-eap reauth-period <NUMBER>
source address for the NAS request to the RADIUS
set wifi wlanX encryp wpa
-eap
source
-ipaddr <ADDRESS>
WPA protocol version
set wifi wlanX encryp wpa-eap version [1|2|auto]
N.B.: All the parameters are enabled only if the wlan is activated with:
set wifi wlanX enable [ yes | no]
The default value is "no". The first access point is (wlan0) is always enabled, so the enabling of a specific
wlan applies only at wlan1 to wlan7.
To Next Page
Loading...
