SECTION : CARE AND MAINTENANCE
|
83
Make sure these steps are followed before using your boat:
• Check and inspect the fuel and exhaust systems, the engine cooling
and lubrication systems.
• If the swim platform was removed for storage, reinstall it.
• Charge and reinstall battery into boat.
• Check engine and bilge for signs of nesting animals; clean as
necessary.
• Check entire engine for cracks and leaks caused by freeze damage.
• Check hose condition and all hose clamps for tightness.
• Install bilge drain plug or any other drain plugs removed. Make sure all
plugs are installed correctly.
• Perform daily maintenance. If not performed during lay-up, perform
annual maintenance.
• Check and lubricate steering system.
• Remove blocks from under trailer frame.
• Tighten tie-downs and trailer winch line.
• Check tire pressure and lug nuts on trailer.
• Take the boat to the water and start it. It may take a minute of cranking
to allow the fuel system to prime. Allow a one-minute cooldown period
for every 15 seconds of cranking. When the engine starts, keep a close
watch over the gauge readings, and check for leakage and abnormal
noises. Keep speeds low for the first 15 minutes until the engine has
reached normal operating temperature.
To Next Page
Loading...
