SECTION : TROUBLESHOOTING AND SERVICE REQUIREMENTS
|
90
TIGÉ MAINTENANCE SCHEDULE DAILY WEEKLY REGULAR ANNUAL 300-HRS.
Smell bilge area for fuel vapors
Check and tighten all steering system bolts
and connections
Check rudder, tiller arm bolt and safety
setscrew
Lubricate rudder stuffing box and steering
support tube
Lubricate cables
Replace cables If stiffness continues after lubricating
Check bilge pump operation
Check blower operation
Adjust and tighten throttle linkage
Inspect shaft packing
Check shaft alignment/ensure it is within .003
Check and tighten motor mounts
Tighten pylon and tower mounting bolts
Tighten all hardware and fasteners
Oil teak swim platform (as needed)
Change engine oil and filter
(every 100 hrs. or annually)
Change fuel water separator
(every 100 hrs. or annually)
Change transmission fluid
(every 100 hrs. or annually)
Check engine oil
Check transmission
Check water pickups for debris or marine growth
If equipped with a strainer, check and clean
If operated in salt water, flush engine/cooling
system and boat
IF PROPELLER STRIKES AN OBJECT, INSPECT DRIVE TRAIN IMMEDIATELY!
300-HOUR SERVICE REQUIREMENTS
This service must be performed to keep warranty active. Please see your
dealer.
Boat # _____________________________________________________________
Service Date _______________________________________________________
Service Provider ____________________________________________________
I certify that the 300-Hour Service has been conducted and a copy will be
sent to: Tigé Boats, Inc., 1801 Hwy. 36 Abilene, TX, 79602
Mechanic Name _____________________________________________________
Mechanic Signature _________________________________________________
PLACE STAMP HERE
To Next Page
Loading...
