Tiger Bengal - Step 12: Roof Felting; Applying the Roof Felt

TIGER BENGAL LOG CABIN GENERAL INSTRUCTIONS
12
gersheds.com 0113 205 4189 sales@gersheds.com
Step 12:
FELT THE ROOF FELTING THE ROOF
• 12.1 Rolllargeanglecutfeltpiecealonglowsideofroof(Piece1)leavingsucientoverhangtofolddown
  ontoloweredge.Donotfoldunderneathroof.
(Detail K1 & K2)
  SecuretoroofskirngusingCN20atapprox.100mmintervals.(Detail K2)
  Ensurethefeltisght,thensecurethetopedgeoffeltusingCN20atapprox.100mmintervalsalong
  thefullength.Securealongridgesusing5xCN20.
• 12.2 Repeatprocessforalllowerseconsoffelt.
• 12.3 Placesmalleranglecutfeltpiece(Piece2)asshown.Overlapthetoppieceoffeltwiththe
  boompiecebyapprox.75mm.
(Detail K3)
NOTE: THE EDGE OF THE FELT WILL NOT BE FLUSH WITH THE RIDGE. THIS WILL BE COVERED BY
CUT FELT IN STEP 12.4.
• 12.4 Use2.5mcutpiecesoffeltcovertheridgeswherethefeltoverlaps.SecureusingCN20alongedgesof
  feltat100mmintervals.
• Reaachacorntop,trappingfeltatpeakinbetweentheacorntopandroofboard.
K1 K2 K3
INCORRECT FELT CORRECT FELT
CN20
CN20
CN20
ROOF BOARD
12.212.1
12.412.3