Tiger JNP-1803 User Manual

11
10
11
10
English
6
Close the outer lid.
To close thw outer lid, simply lower it until the
lid latch engages with the lid catch with click.
Outer lid
Note
● If the outer lid is not closed properly, the cooking
efciencywillbebadlyaffected.
7
Connect the power plug to an
outlet.
Note
● Do not plug the AC cord in until actual cooking
starts. Anytime this rice cooker is plugged in and
the switch is not immediately set for cooking, the
warming circuit is operating.
● Unplug power cord when not in use.
8
Press the switch button.
Press the switch button on and a click will be
heard.
The start lamp will turn on indicating the rice
is starting to cook.
Start lamp
Switch button
9
Steam the rice for 15 to 20 minutes.
When the switch button is turned off and the
Keep Warm function engages, the actual
cooking proceeds to steaming. Therefore,
keep the lid closed for about 15 minutes.
Start lamp Keep Warm
lamp
Note
● Do not press the switch button for cooking while
the Keep Warm function is on.
10
Stir and loosen the cooked rice.
Spatula
Note
● Do not forget to loosen the cooked rice with the
spatula.
11
The Keep Warm function
continues.
Note
● Whileserving,becarefultokeeptheangedrim
of the inner pot free of rice. Failure to do so may
prevent the lid from closing properly and cause
the Keep Warm function not to work properly.
12
Disconnect the power plug from
the outlet.
4
How to USE (Porridge Cooking)
ThisfunctionisonlyavailablefortheJNP-1803.
1
Measure the rice.
Always use the measuring cup supplied with
the rice cooker.
Alevelllingofriceinthesuppliedmeasuring
cup equals about 0.18 L.
2
Wash the rice.
3
Put the desired amount of rice
and water into the porridge pot.
CUP
MAX
1
2
If 1 cup of rice are put
into the porridge pot,
then water should be
poured until the water line
reaches approximately
the number "1" level of
the scale stamped on
the inside of the pot.
MAX. LEVEL
Do not attempt to cook
more than the amount.
Porrigde pot
4
Put 2 cups of water with the
measuring cup accessory into
the rice cooker. And install the
porridge pot into the inner pot.
Inner pot
Porridge pot
Water
Note
● Two cups of water between inner and outer pot
can be adjustable to your taste.
● Volume of water between inner and outer pot
will be also adjustable to grade of rice and water
temperature.
● If you prefer more soft porridge, add more water
between inner and outer pot and cook agian.
5
Place the inner pot in the rice
cooker.
Make sure that the pan has direct contact
with the heating plate by turning it slightly
from right to left until it sits properly.
6
Install the inner lid to the outer
lid by pressing the inner lid over
the inner lid shaft.
7
Close the outer lid.
To close thw outer lid, simply lower it until the
lid latch engages with the lid catch with click.
8
Connect the power plug to an
outlet.
9
Press the switch button.
Press the switch button on and a click will be
heard.
The start lamp will turn on indicating the rice
is starting to cook.
10
When the porridge has nished
cooking, the switch button will
pop up and a click will be heard.
At the sametime the strat lamp will go out and
keep warm lamp will go on, which means the
keep warm feature is working.
Note
● Remove and empty dew collector after every use.
● During keeping porridge warm for a long time,
porridge may become sticky.
● Please note that the steam vent on top of the
outer lid is very hot and steam will come out
during cooking.
● Duringporridgecooking,pop-upalittlesteam
(dew) from steam vent, if dew does spill out, open
the outer lid immediately and continue cooking.
Porridge cooking capacity
Cookingcapacity:0.09-0.36
Using180mlmeasuringcup:0.5-2cup

Tiger JNP-1803 Specifications

General

Brand	Tiger
Model	JNP-1803
Category	Rice Cooker
Language	English