Please retain instrucons for future reference
Step 4:
BEGIN BUILDING WALLS
• Place 1st layer of logs on the edges of the bearers. Ensure half logs are put down rst.
See construct diagram for build order.
• Measure corner to corner diagonally to make sure cabin oor is square. If both values are equal, your frame is
square. Realign the oor unl square. Do not trim.
• Screw logs into tanalised bearers using 3x S80 per log. (1x S80 in centre, 1x S80 per end notch)
• For xing through notches.
(Detail D1)
• For xing through half log. (Detail D2 & D3)
• Check that oor is level using a spirit level.
D1 D2 D3
S80 S80 S80
09
To Next Page
Loading...
