How to clean white material floating in Tiger PDR-A30U?
If you notice white material floating in the hot water of your Tiger Water Heater and the inner container appears dirty, this is typically due to a reaction of minerals in the water. It's not discoloration, rust, or peeling. To resolve this, clean the unit with Citric Acid.
How to fix a Tiger Water Heater when it does not boil and the display is blank?
If your Tiger Water Heater isn't boiling water and all the lamps are off with a blank display, the first thing you should do is connect the plug to ensure the unit is receiving power.
Why is the water not hot enough in my Tiger PDR-A30U Water Heater?
If the water in your Tiger Water Heater isn't hot enough, here are a few things to check: * If you've selected Energy Saving Mode, press the Temp.Set or Unlock key to bring it up to the set temperature. * Ensure the unit is completely upright, especially if hot water was dispensed while it was tilted. * Make sure the plug is properly connected. * If it is set to lock automatically, press the Unlock key once before dispensing hot water.
What to do if Tiger PDR-A30U Water Heater doesn't boil after refilling?
If your Tiger Water Heater doesn't start boiling after refilling, and the boil light isn't lit, it could be due to a couple of reasons: * If you filled the container with hot water hotter than approximately 122°F, refill it with cooled or cold water. * You may need to manually start the boiling process by pressing the Re-Boil/Timer key.
Why does my Tiger PDR-A30U Water Heater smell?
If the hot water from your Tiger Water Heater has an odor, consider these points: * The chlorine smell may remain depending on the amount of disinfectant chlorine in the tap water. In this case, select boiling cycle with dechlorinate. * A smell of plastic or other materials is normal for the first several uses and should become less noticeable with time.
Why does hot water come out on its own from my Tiger PDR-A30U?
If hot water is coming out of your Tiger Water Heater on its own, make sure that the water level is below the 'Max water level.'
Why is the boiling sound louder than usual in my Tiger PDR-A30U Water Heater?
If the boiling sound from your Tiger Water Heater seems louder than usual, it could be that the inner container is dirty. Try washing the inner container with citric acid.
What does it mean when the boil and keep warm lamps flash alternately on my Tiger Water Heater?
If your Tiger Water Heater's Boil and Keep Warm lamps are flashing alternately and signs appear on the display, indicating Dry-Boil Protection, it might be due to insufficient water in the container. Unplug the unit, refill it above the refill level indicated on the water volume indicator, let it sit for a while, and then plug it back in.
Covers precautions related to plugs, cords, outlets, water levels, and prohibited uses.
Step-by-step guide to filling, closing, powering, and starting the boiling process.
Steps to unlock the unit and dispense hot water using the dispense key.
How to select and activate the Energy Saving Mode on the unit.
How to set the timer for 6 to 10 hours for energy saving.
Guidance on removing mineral deposits and discoloration using citric acid.
Procedure for a 90-minute cleaning cycle using citric acid for soft water.
Procedure for an 8-hour cleaning cycle using citric acid for hard water.
Addresses problems like water not boiling, slow boiling, or unusual sounds.
General| Model | PDR-A30U |
|---|---|
| Weight | 2.3 kg |
| Color | White |
| Keep Warm Function | Yes |
| Timer Function | Yes |
| Voltage | 220-240V |
| Type | Electric |
| Safety Features | Overheat Protection, Dry Boil Protection |
| Dimensions | 229 x 293 x 306 mm |
To Next Page
