How to clean white material floating in the Tiger PDR-S Water Heater?
The white material floating in the hot water of your Tiger Water Heater is likely due to a reaction of minerals in the water, not discoloration or rust. Clean the unit with Citric Acid.
Why is my Tiger Water Heater not heating water hot enough?
There could be several reasons why your Tiger Water Heater isn't heating water adequately: * If you've selected Energy Saving Mode, press the Temp.Set or Unlock key to bring it up to the setting temperature in a minute. * Ensure the unit is completely upright, as tilting during dispensing can affect the temperature. * Verify the plug is securely connected. * If it's set to lock automatically, press the Unlock key once before dispensing.
What to do if my Tiger PDR-S doesn't boil after refilling?
If your Tiger Water Heater doesn't start boiling after refilling, it might be because you filled it with hot water (hotter than approximately 50°C). Refill with cooled or cold water. You can also try to start the boiling by pressing the Re-Boil/Timer key.
Why does the hot water from my Tiger Water Heater smell?
The smell from your Tiger Water Heater could be due to a few reasons: * The chlorine smell may remain depending on the amount of disinfectant chlorine in the tap water. Select boiling cycle with dechlorinate. * There may be a smell of plastic or other materials for the first several times, they become less noticeable with use.
Why does hot water come out on its own from my Tiger PDR-S Water Heater?
If hot water is coming out on its own from your Tiger Water Heater, ensure that the water level is below the 'Max water level.'
What to do if my Tiger PDR-S doesn't dispense water?
If your Tiger Water Heater isn't dispensing water, the mesh filter or the inside pump might be dirty. Clean the unit with Citric Acid.
Why is my Tiger PDR-S Water Heater boiling louder than usual?
If your Tiger Water Heater sounds louder than usual when boiling, the inner container might be dirty. Wash the inner container with citric acid.
Why is my Tiger PDR-S not boiling and producing no steam?
If your Tiger Water Heater is not boiling and there is no steam, check if you have selected Energy Saving Mode. If so, select a boiling cycle with dechlorinate.
How to fix a Tiger PDR-S Water Heater when it doesn't boil and all the lamps are off?
If your Tiger Water Heater isn't boiling and the lamps are off, make sure the plug is properly connected.
What does it mean when the boil and keep warm lamps flash alternately on my Tiger PDR-S Water Heater?
If the Boil and Keep Warm lamps are flashing alternately on your Tiger Water Heater, it indicates the Dry-Boil Protection is activated. This is often due to insufficient water in the container. Unplug the unit, refill water above the refill level, wait a while, then plug it back in. Avoid pouring water with excessive force when refilling.
General| Brand | Tiger |
|---|---|
| Model | PDR-S |
| Category | Water Heater |
| Language | English |
To Next Page
