USA - ENGLISH
Tiiwee X1 Alarm Kits
1. Disclaimer
2. Introduction
3. System overview
4. Installing your Tiiwee alarm system in four simple steps
5. Daily use of your alarm system
6. Expanding your system
Connecting additional door sensors
Connecting PIR motion detectors
Connecting remote controls
Adding additional sirens to your system
7. Deleting accessories or changing the zones
Clearing all sensors from a zone. Reconnecting a sensor to a zone.
Disconnecting remote controls
8. Battery lifetime, and low battery voltage
9. Replacing batteries
10. Resetting the X1-siren to factory settings
11. tiiwee window sensor 03
12. tiiwee PIR sensor 02
13. Customer service
14. Warranty and liability
15. FCC regulation
1. Disclaimer
Testing
It is recommended that the alarm is tested immediately after installation and at regular intervals not
exceeding one month. Note: a cloth can be used to cover the siren and reduce the sound output of
the alarm during testing.
Warning
Risk of personal injury: prolonged exposure to the alarm siren may cause permanent hearing loss. For
indoor use only. Do not use in wet locations.
Limitations of alarm products
Test product regularly to ensure it functions in accordance with these instructions. Tiiwee B.V. is not
providing insurance or any guarantee that the risk of burglary or robbery will be reduced or
prevented even if this product is used properly. Tiiwee B.V. recommends that users obtain proper
insurance coverage for these risks. Tiiwee B.V. does not represent or warrant that this product may
not be compromised or circumvented, that it will provide proper or adequate warning, or that the
To Next Page
Loading...
