EasyManua.ls Logo

TileVision LRC - How to Control a Device; Tilevision Codes; Entering a Brand Code

TileVision LRC
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Press and release the device button: TileVision® (
TV
), satellite receiver (
SAT
) or
DVD recorder/player (
DVD
) that you wish to control. Press the function button you
require. The LEDs will light to conrm that a signal is being sent and which device
is being controlled.
To select a dierent device to control, press and release the device button:
TileVision® (
TV
), satellite receiver (
SAT
) or DVD recorder/player (
DVD
) that you wish
to control. Press the function button you require. The LEDs will light to conrm
that a signal is being sent and which device is being controlled.
TileVision® Codes
The TileVision® learning remote control is supplied with the TV device button
set to the TileVision® TV22/FR1 and TV26/FR2 model remote control codes. If
these remote control codes are accidentally erased, or if an alternative TileVision®
model’s remote control codes are required, enter the appropriate three digit code
for the TileVision® model as shown below.
Entering a Brand Code
1 Locate the three digit code in the brand list, for the satellite receiver or DVD
recorder/player that you wish to control.
2 Press and hold down the Television (
TV
), satellite (
SAT
) or DVD (
DVD
) device
button until the red light stays on.
3 Enter the three digit code using the number buttons 0–9.
4 As each digit is entered the red light will ash once and then remain on.
5 If the three digit code is correct the red light will go out. If the three digit code
is incorrect the red light will ash twice and then remain on.
6 Press the original device button again to exit the code entry mode.
Note: If a three digit code is not entered within 30 seconds the red light will ash
twice and exit code entry mode. Entering a three digit code will delete/erase the
programmed buttons for that device.
How to Control a Device
For button assignment
information see the
table on page 9.
TileVision® Model Three Digit Code
TV22/FR1, TV26/FR2 368
TV19/FR1, TV26/FR1 371
TV17/FR5,TV23/FR3 369
TV17/FR4, TV17/FR3, TV17/FR2 370
TV23/FR2, TV23/FR1 370