6
High levels of ambient light such as natural sunlight or energy ecient uorescent
lights should be avoided when manually programming the remote control.
Any button other than the device buttons
TV
,
SAT
and
DVD
and the
SET
button can
be manually programmed.
Manually Programming a Button
1 Place the original remote control and the learning remote control roughly
10 mm apart facing ‘head-to-head’ with each other.
2 On the learning remote control press and release the required device button,
TV (
TV
), satellite (
SAT
) or DVD (
DVD
) as appropriate.
3 Press and hold the SET (
SET
) button on the learning remote control until the red
light lights and remains lit. The remote control is now in learning mode.
If the red light does not turn on, go back to step 2 and try again.
4 On the learning remote control press and release the button that is to be
programmed. The red light will ash rapidly.
5 On the original remote control, press and hold the button that is to be learned.
When the red light on the learning remote control ashes three times and
then remains lit the code has been learnt. If the red light does not ash, repeat
steps 4 and 5.
Note: If step 5 is not completed within 15 seconds the learning remote control
will exit learning mode and the light will stop ashing.
6 Repeat steps 4 and 5 to program other buttons.
7 Once the required buttons have been programmed press the SET (
SET
) button
again on the learning remote control to exit learning mode.
Deleting All Button Programmes for One Device
1 Press and release the appropriate device button TV (
TV
), satellite (
SAT
) or
DVD (
DVD
) to select which device’s programs are to be deleted.
2 Press and hold the chosen device button together with SET (
SET
) button until
the red light ashes three times.
3 All of the programmed buttons for the chosen device have now been cleared
of their programming.
Deleting programs from buttons does not delete any three digit brand code
which has been entered.
Manual Programming and Program Deletion
To Next Page
Loading...