TileVision LRC - Five Flashes; Checking;Recalling a Device Code

5
To nd out which three digit code is controlling any device:
1 Press and release the device button: TV (
TV
), satellite (
SAT
) or DVD (
DVD
) for
which you want to nd the code.
2 Press the same device button again, together with the OK (
OK
) button and
release both buttons.
3 The red light will ash.
4 Count the number of ashes for each digit in the three digit code.
5 The red light will remain o for a short time between numbers.
6 When all three numbers have been ashed the red light will remain o.
One Flash = 1
Two Flashes = 2
Three Flashes = 3
Four Flashes = 4
Five Flashes = 5
Six Flashes = 6
Seven Flashes = 7
Eight Flashes = 8
Nine Flashes = 9
Ten Flashes = 0
For example:
Press and release the DVD (
DVD
) button.
Press and release the DVD (
DVD
) and OK (
OK
) buttons.
The remote control would then show nine ashes (9), pause, two ashes (2),
pause, and one ash (1), to conrm the three digit code of 921.
Checking/Recalling a Device Code