IM2019
12
SLEEP mode
This mode can be enabled using the «SLEEP» and « » buttons
Note: It is impossible to turn on the SLEEP mode in the dehumidifying or fan modes.
COOL mode
Press «MODE» until the «COOL» indicator lights up. Click buttons « » or « » to select the
needed room temperature. The temperature can be set in the range 16 °C−31 °C. Press the
«SPEED» button to select the fan speed.
DRY mode
Press «MODE» until the «DRY» indicator lights up. In this mode, you can’t select or adjust the
fan speed temperature. Close windows and doors to achieve the best drying effect. Do not put
the duct to window.
FAN mode
Press «MODE» until the «FAN» indicator lights up. Press the «SPEED» button to select the fan
speed. You can’t adjust the temperature. Do not put the duct to window.
10. MAINTENANCE
ATTENTION!
Disconnect the unit from the mains before cleaning.
1. When cleaning the air conditioner, do not use gasoline, solvents and other chemically active
substances.
2. To avoid electric shock and damage to electrical components, do not pour water on the air
conditioner from a tap or a hose.
3. Do not use the air conditioner if the power cord is damaged. On the subject of replacing a
damaged power cord, contact an authorized service center.
Air filter
Clogging with dust particles impairs the air conditioner operation efficiency, therefore clean the
filter no less than once in two weeks.
Filter removal/installation
On the back of the housing, slide the plastic lock, unscrew the four screws and pull out the filter
frame (as shown in the figure below)
To Next Page
Loading...
Need help?
General
