English
10/109
6.
INSTRUCTIONS PUTTING IT INTO
SERVICE
6.1. LIST OF MATERIAL
The machine includes the following items which you
will find inside the box:
• Machine
•
Flexible tube
•
Straight trottle tube
•
Straight tube
•
Blow Nozzle
•
Tools
•
Operator manuel
Carefully remove the items from the box and make
sure that all the items on the list are in it.
Carefully inspect the product, to make sure
there are no damaged pieces. If there are damaged
or missing pieces, do not use the machine until the
problem has been resolved. Using it in poor
condition may cause, fire or personal injuries
6.2. ASSEMBLY
ATTENTION! To connect the blowertube you
must insert the tubes so that it fits perfectly as far
as possible into the opening (1) and then turn
towards the bottom of the opening (2).
Installation of the tubes:
- Connect the straight trottle tube (3) to the throttle
lever and then to the flexibele tube (2) and then connect
the flexible tube to the curved one (1) with the clamp.
- Connect the blow nozzle (5) to the straight tube (4)
and then connect to the straight trottle tube.
6.3. MIX OF FUEL AND OIL
Use fresh unleaded fuel together with 2-stroke
synthetic oil specialy made for garden tools (Ratio:
4,0%).
Engine fuel: mix with 100% synthetic oil
(fuel 25: oil 1, that is 4%). Mix the fuel
and oil carefully in a jerry can approved
for this use.
Fuel that has been stored for more than 2 months will
make it more difficult to start the machine and the
engine will not perform well. If the fuel has been in
the machine's tank for more than 2 months, take it
out and replace it with fresh fuel.
Refuelling the blower
Choose a clear area to best perform this
operation.
To Next Page
Loading...