15/109
Depending on the symptoms you observe, you may detect the cause of the problem and solve it.
The engine does not start:
9. Troubleshooting
Cylinder compression is
normal
The spark of the
spark plug is
correct
Probable cause Corrective action
There is no fuel in the tank Add fuel to the tank.
The fuel filter is dirty Clean the filter
There is water in the fuel Change the fuel
Yes Yes The fuel used is not appropriate
Use fuel with an appropriate octane level +
100% synthetic oil
The safety switch of the ventilator is loose or
the cover is not closed correctly.
Tighten the safety switch.
The carburetor is dirty
Bring your machine to a TIMBERPRO
authorized dealer
The switch is in the "OFF" position
Put the switch in the "I"
position
Yes No The spark plug is dirty Clean the spark plug
The spark plug wire is not connected.
Connect it
The spark plug is loose Tighten it
Loss of compression
Piston, parts of the piston, worn cylinder
Bring your machine to a TIMBERPRO
authorized dealer
Yes The cylinder is scratched
Bring your machine to a TIMBERPRO
authorized dealer
The engine does not turn Seized engine
Bring your machine to a TIMBERPRO
authorized dealer
To Next Page
Loading...