Fingerscanner Technology for Time Attendance & Access Controller
14
Example:
Unlock Group 12 Means user in Group 1 and Group 2 should be
verified together (within 10 seconds) to access door.
Note:
! After the first user is verified, the next user verification fails for 5 times, then
the first person verification is aborted (need to repeat again).
! After the first user is verified, if the next user does not do verification for 10
seconds, the first person verification is aborted (need to repeat again).
5.3.5 Unlock Time, set the time delay for locking (in minute)
5.3.6 Lock Type Set,
5.3.6.1 Alarm Type, set the type of alarm mode
NG Switch off the alarm mode.
NO Alarm with Normally Open condition
NC Alarm with Normally Close condition
5.3.6.2 Alarm Delay, set the alarm time delay (in seconds).
This option is to set the time delay to trigger the alarm if the lock has not
reached its normal condition after “Unlock Time” (above index 5.3.5) has
finished.
Example:
Lock Mode (NC), Unlock Time is 10 seconds, Alarm Delay 5 seconds.
This means, after the door has opened for 10 seconds and still not
closing (has not reach back its normal condition), then in 5 seconds，
the alarm will sound. Close the door properly (normal condition) to
switch off the alarm.
5.3.7 Access Mode
5.3.7.1 G. Mode, to set (on/off) the General Mode
5.3.7.2 Users, to set how many users should be verified before open/access
door (can be set 1-5 users).
! G. Mode is set “No”, machine will use the “Unlock Group” setting to access
door.
To Next Page
Loading...