9 10
• Important: After setting a clock time which falls
within a programmed “ON” period, the unit will
not switch “ON” The programmed time must
be after the current time on the clock for the
programme to be switched on. If you require
the programme to be “ON” and clock time falls
within the programmed time use the override
button which will turn on the unit until the next
programmed “OFF” sequence.
6b Planning The programmes
• A programme is a pair of ON/OFF settings which
will dictate when the load will switch “ON”
and “OFF”.
• Programmes can be set before or after setting
the clock time.
• Programmes can be carried over midnight
by programming the required “ON” time
and then “OFF” at 0:00 for the first day,
followed by an “ON” at 0:00 and the required
“OFF” time for the second day. Please refer to
the table on page 10 for the setting a programme
using this method.
To Next Page
Loading...
