10
• On the transmitter, press and hold both the + and Frost/Night
Set-back buttons at the same time until the flashing blue Learn/Manual
light goes off. This should take approximately 3 seconds.
• The transmitter and receiver are now paired.
Press and hold the Learn button
for 10 seconds
The blue Learn/Manual light
will start to flash
Press and hold the
Select button for
1 second, and then
at the same time press
and hold the Light/Frost
protection button,
for approximately
3 seconds
• Press and hold the Learn button on the front of the receiver for
10 seconds until the blue Learn/Manual light starts flashing,
the button surrounds will illuminate.
The flashing blue Learn/Manual
light will turn off
To Next Page
Loading...
