T300 T550 Hardware Installation Guide. Page 13
7. Configuration
Before configuring the NTP server, you will need to acquire the following basic configuration information:
IP address,
Network mask,
Default Gateway,
Domain name servers
or confirm availability of a network DHCP server for dynamic networking configuration.
The T300 T550 can be configured in any one of three ways:
• Over a network using a web browser on a PC connected to the same network segment.
• Using a web browser on a PC using a peer-to-peer (direct cable) network connection.
• Using a dumb terminal emulator on a PC using a RS232 serial connection.
Please refer to the T-Series User Guide (Document Number T1300-01) for configuration information.
2020 TimeTools Limited. All Rights Reserved.
To Next Page
