T300 T550 Hardware Installation Guide. Page 6
1. Introduction
Network Time Protocol (NTP) can be used to synchronize the time on network clients, across an IP network, to the
correct time of an NTP time server. TimeTools NTP Servers provide a stratum 1 NTP Time Server for ensuring the time is
correct across an entire network.
The Network Time Server acquires time from the satellite constellation and distributes time across a network using the
TCP/IP Network Time Protocol (NTP).
2. Key Features
Model T300: 16-channel, high sensitivity GPS timing receiver.
Model T550: 32-channel, multi-constellation timing receiver providing reception of GPS, GLONASS, BeiDou and is
Galileo ready
*1.
Timing receiver synchronises to less than 15 nanoseconds (GPS Locked).
Can operate with outdoor, indoor or window located antenna, saving on cabling costs.
T550: Integrated high-stability TCXO oscillator provides holdover during loss of signal lock.
NTP accurate to less than 3 microsecond (3x10-6 seconds) UTC (GPS Locked).
Synchronize in excess of 100,000 clients.
Model T300: Single 10/100 Mbit auto-sensing, auto-MDIX Ethernet ports.
Model T550: Dual 10/100 Mbit auto-sensing, auto-MDIX Ethernet ports.
IPv4 and IPv6 Internet Protocol.
Integrated universal AC mains input PSU for world-wide operation.
Made in UK.
*1 Hardware ready: a firmware update is required to enable the
Galileo constellation.
2020 TimeTools Limited. All Rights Reserved.
To Next Page
Loading...
