TIMEX
®
IRONMAN
®
Classic 50 Move+ Owner’s Manual Page 7
ALARMS
Your TIMEX IRONMAN Classic 50 Move+ is equipped with three alarms. When alarms are activated, the
Indiglo® night-light and alarm icon will flash and you will get an audible alert; push any button to silence
those alerts. If no button is pressed the alarm will sound for 20 seconds and repeat once after 5
minutes.
To set your alarms:
1. Push the Mode button until ALARMS is on the top of the display.
2. The top banner on your Classic 50 Move+ will quickly change from displaying ALARMS to
displaying ALM 1.
3. Push the Set/Recall button.
4. Push the Start/Split and/or the Stop/Reset buttons to adjust the hour digits.
5. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to adjust the minute
digits.
6. Push the Mode button, use the Start/Split button to select AM or PM.
7. Push the Mode button, use the Start/Split and/or Stop/Reset buttons to select the alarm
frequency: DAILY, WKDAYS, WKENDS, MON, TUE, WED, THU, FRI, SAT, OR SUN.
8. Push the Set/Recall button to confirm and exit.
9. Push the Stop/Reset button to change to the next alarm settings.
10. Repeat steps 3 through 9 to adjust all three alarms in the watch.
11. You will now see an alarm clock icon on the Time of Day screen; this signifies the presence of an
active alarm/alarms.
NOTES:
The alarms can quickly be deactivated/reactivated by accessing the alarms (ALM 1, ALM 2, ALM
3) and pushing the Stsrt/Split button.
When in Alarms Mode, push the Stop/Reset button to scroll through all three available alarms.
To Next Page
Loading...
Need help?
General