Timex M594 - Page 5

TIMEX
WATCH OPERATION GUIDE
TIMEX CONFIDENTIAL PROPRIETARY INFORMATION
Quality Control
Page 5 of 6
Model No(s):
M594 / M657
M892
Part Name:
WATCH HEAD
Doc. No./Rev.:
20170304
Prepared by:
GAstida / HJSagun
Approved by:
Reviewed by:
ACCabasan
DGriffith
M594-M657-M892 Watch Operation Guide Doc. No./Rev. 20170304
2.5 INTERVAL TIMER
You can set two Timers that countdown in sequence.
Interval Timer Set-Up:
a. Press MODE button until INTTMR appears.
b. Press SET/RECALL button. INT 1 flashes.
c. Press MODE (NEXT) button. Hour digits flash.
d. Press START/SPLIT (+) or STOP/RESET (-) button to increase or decrease HOUR.
e. Press MODE (NEXT) button and press START/SPLIT (+) or STOP/RESET (-) button to set minutes.
f. Press MODE (NEXT) button and press START/SPLIT (+) or STOP/RESET (-) button to set seconds.
g. Press MODE (NEXT) button and press START/SPLIT (+) or STOP/RESET (-) button to select STOP AT END or
REPEAT AT END.
h. When return to INT 1, press START/SPLIT (+) or STOP/RESET (-) button to change to INT 2 (Interval 2).
i. Press MODE (NEXT) button then follow steps c to g.
j. Press SET/RECALL (DONE) button to confirm and exit.
Interval Timer Operation:
a. Press MODE button until INTTMR appears.
b. Press START/SPLIT button to start INTERVAL TIMER.
c. Press STOP/RESET button to stop INTERVAL TIMER.
d. Press and hold STOP/RESET button to reset INTERVAL TIMER to pre-set value.
e. Press MODE button to exit TIMER mode and return to Time-of-Day display.
NOTE:
 When first countdown is complete, Timer proceeds to the next non-zero interval that is set. INDIGLO night-light flashes
and beep sounds between each interval.
 If you set both Timers in interval Timer to repeat, Timer will countdown both intervals and then repeat the entire
sequence.