3
ENGLISH 032-095000
Register your product at www.timex.com
REVISED 7.14.15
BATTERY REPLACEMENT
Before replacing the battery, it is recommended that you synchronize to
the phone to make sure you have retrieved all of the latest activity data
from the watch. After the battery has been replaced, the watch will automat-
ically calibrate the sub-dial hands. Upon completion of the auto-calibration
process, the upper sub-dial hand will point to “OFF” and the lower sub-dial
hand will be positioned at ZERO. The activity tracking function will be off.
You will need to adjust the center hand and synchronize the watch with the
Smartphone application. Press button A and the upper sub-dial hand will
move to the Bluetooth
®
symbol. Perform the synchronization of the watch
and Smartphone application. Once the watch has been synchronized with
the Smartphone, the activity tracking function can be activated.
STORING THE WATCH
The power may be removed from the watch for storage. Pull the crown out
to the outer position. The hour, minute and second hands will immediately
cease to operate and the activity tracking function will be completely inactive
after 30 minutes with the crown in this position.
FIRMWARE UPDATE
As updates for the Smartphone application are published you will receive
notification through your Smartphone application. While the synchronization
is occurring with the update the lower sub-dial hand will indicate the
progress of the download, moving from 0 to 100%.
STRIDE LENGTH ADJUSTMENT
The Timex Metropolitan+ uses an algorithm for distance measurement which
automatically determines your stride, based on your height and speed. If
you find that the distance reported does not match your actual walking or
running distance you can calibrate the distance by up to +/- 25% via the
Smartphone application. This is done by the distance adjustment option on
the watch section of the application.
WATER RESISTANCE
WATER RESISTANCE
WARNING: TO MAINTAIN WATER RESISTANCE, DO NOT PRESS ANY
BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push buttons and case
remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
If your watch is water-resistant, meter marking or (O) is indicated.
Water-Resistance Depth p.s.i.a. * Water Pressure Below Surface
30m/98ft 60
50m/164ft 86
100m/328ft 160
200 m/656ft 284
* pounds per square inch absolute.
©2015 Timex Group USA, Inc. TIMEX, TRUE SINCE 1854 TIMEX and INDIGLO are
registered trademarks of Timex Group B.V. and its subsidiaries. The Bluetooth word mark
and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Timex is under license.
FCC NOTICE (U.S.) / IC NOTICE (CANADA):
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d’un type et d’un gain maximal
(ou inférieur) approuvé pour l’émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l’intention
des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte
que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l’intensité nécessaire à l’établissement d’une communication satisfaisante.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio TV technician for help.
DECLARATION OF CONFORMITY
Manufacturers Name: Timex Group USA, Inc.
Manufacturers Address: 555 Christian Road
Middlebury, CT 06762
United States of America
declares that the product:
Product Name: Timex® Metropolitan+
Model Numbers: M372
conforms to the following specifications:
R&TTE: 1999/05/EC
Standards: CENELEC EN 55022
ETSI EN 301 489-1
ETSI EN 301 489-3
ETSI EN 301 489-17
ETSI EN 300 440-2
LVD: 2006/95/EC
Standards: IEC 60950-1
CENELEC EN 60950-1
Digital Device Emissions
Standards: FCC 47CFR 15C Part 15 Subpart C 15.247 (Bluetooth)
FCC 47CFR 15B clA Part 15 Subpart B Unintentional
Radiators
FCC 47CFR 15B clA Part 15 Subpart C 15.247 (Bluetooth)
IC RSS 210 Issued:2010/12/01
ICES 003
SAI AS/NZS 4268
Agent:
Sam Everett
Quality Regulatory Engineer
Date: 11 July, 2015, Middlebury, Connecticut, U.S.A.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
