8. Adjusting built-in T-touch or TCS1 sensitivity
1. Press memory buttons 1 & 2 for 5 seconds, the display will show the current sensitivity level (0~9) by
flashing. (Note 4)
2. Press the or button to adjust the sensitivity level. If no button is pressed within 5 seconds, the
system will resume normal operation mode.
3. After adjusting, press memory buttons 1 & 2 again (or wait for 5 seconds), and the handset will go back
to normal operationmode.
While adjusting the sensitivity, if the TCS1 is connected with the control boxwhich has built-in T-
touch, , both sensitivities will be changed simultaneously.
Note 4: Some control boxes may not support this functionality. If the control box does not support built-in T-touch or
no TCS1 is connected, the display will show 0-0.
9. Power Saving Function - Waking Up the
Control
The digital display automatically turns off if no buttons are pressed within 25 seconds. Press any button
to light up the display again.
The system goes into <0.1W standby mode (Note 5) if no buttons are pressed within 30 seconds. Long
pressing any button will wake up the system and show desk height on the digital display.
Note 5: It depends on the control box whether it will support 0.1W standby mode or not.
To Next Page
Loading...