EN
24
• Insert the hose end into the port. You should
hear two “Clicks” if done correctly.
Fig.B-10
OPERATION
Preparing for Use (Appliance)
1.Unwrap the power cord and plug into an
electrical outlet.
Fig.C-1
2.Step on the recline pedal to recline the unit for
cleaning position.
Tips:
• Press the button to turn on/off the voice
prompt.
• Press the button twice to switch
languages. (More voice languages will be
added, please refer to the actual product for
now.)
Fig.C-2
3.Press the button and the appliance will start
in AUTO mode by default. Press it again to turn
off the appliance. Switch between AUTO, MAX
and DRY mode by pressing the button.
Fig.C-3
4.In AUTO/MAX/DRY mode, the appliance will
stop working when put uprightly and start
running again when you recline.
Fig.C-4
5.Grip the back carry handle to lift or move
appliance. Empty CWT and DWT after each
use.
Fig.C-5
Note:
• The carpet cleaner differs from the traditional
vacuum cleaner.
• In all modes, it blows hot air, whose
temperature is 70-80°C.
* Appropriate temperature is conducive to dissolve the dirt
and helps surfactant in the solution to decompose the dirt.
• In AUTO/MAX mode, it sprays water when
moving forward and stops spraying when
moving backward.
• Take a spot test on a small and marginal area of
the carpet for colorfastness. Gently rub surface
with a damp white cloth. Then wait ten minutes
and check for color removal or bleed with a
white paper towel.
• During use, don’t keep the appliance at a
resting position for a long time.
Preparing for Use (Accessory
Hose & 2 in 1 Nozzle)
1.Attach the accessory hose, stand the appliance
upright and ensure that it is power on (if not,
press the button), the appliance will enter
in ACCESSORY Mode, the appliance will stop
working when you recline.
Fig.C-6
2.Store the accessories in the bag after use.
Fig.C-7
Note:
Do not vacuum foamed liquid.
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor automatically
detects how dirty the carpet is and applies the
appropriate volume of water spray.
• A red dirt monitoring loop indicates more dirt
is detected, and a blue loop indicates less dirt
is detected. This mode automatically provides
the best cleaning solution.
Fig.C-8
MAX Mode
• In AUTO mode, press the button to enter
MAX mode. The AUTO indicator on the display
will turn off.
• The iLoop only displays the dirty amount, and
the spray volume keeps at the maximum of
“100”.
• In MAX mode, the appliance will apply max
spray volume.
Fig.C-9
DRY Mode
• In MAX mode, press the button to enter
DRY mode. In DRY mode, the dry degree
indicator will change with the humidity
detected by the humidity sensor.
• Press the
button to switch to AUTO mode.
Fig.C-10
To Next Page
Loading...
Need help?
General
